Skip to main content
Fig. 3 | BMC Biomedical Engineering

Fig. 3

From: Biomechanical validation of additively manufactured artificial femoral bones

Fig. 3

Schematic cross-section with inner radius r and outer radius R of the composite. The lined-up laminate strips with thickness tL and width b are shown as red bars (upper left). Upper right shows a transverse section of the prototype. The bottom picture shows a frontal section running through the PC model after biomechanical testing. Wall thickness tapers from the diaphysis towards the proximal parts. Additionally, two zones of different infill densities (shaft and proximal femur) are displayed

Back to article page